Brake Drum: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: To reduce the possibility of uneven braking, always install new rear brake shoes at both ends of an axle.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .

CAUTION: Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.

NOTE: If the brake drum is seized to the wheel hub pilot diameter, tap the center of the brake drum between the wheel studs.

If the brake drum binds on the brake shoes, retract the brake shoes.
1. Move the brake shoe adjuster actuator lever away from the adjuster.
2. Rotate the brake shoe adjuster screw upward to retract the brake shoes.
  
  Fig 1: Identifying Brake Shoe Adjuster Actuator Lever And Adjuster Screw
  Courtesy of FORD MOTOR CO.
Remove the brake drum.