Welding Precautions
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
The proper equipment and settings must be used when welding mild or high strength steel. Metal inert gas (MIG) and resistance spot welding are the preferred methods. Surfaces must be clean and free of foreign materials.
- The correct protective clothing should always be worn.
- Adequate ventilation must be provided to avoid accumulation of poisonous gases.
- A test weld should always be carried out on a test sample.
- Follow equipment manufacturer's prescribed procedures and equipment settings for the type of weld being used.
- Disconnect the battery ground cable from the battery. Refer to BATTERY, MOUNTING AND CABLES .
- On Hybrid vehicles, depower the high voltage traction battery system. Refer to HIGH VOLTAGE TRACTION BATTERY .
- Disconnect on-vehicle modules and protect them from possible heat damage and electrical currents when welding.
- Corrosion protection needs to be restored whenever it is necessary to sand or grind through painted surfaces or E-coat, or when bare metal repairs are carried out.
Underbody misalignment can affect front and rear wheel alignment, the operation of the suspension parts and drivetrain operation. Window glass cracks, door and window opening concerns, and air or water leaks at the doors are often caused by improperly tightened bolts and body misalignment.