LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Automatic Transmission - (Hybrid)) >> In-Vehicle Repair >> Transmission Insulator and Retainer - Upper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly.
  2. Support the transaxle with a suitable floor jack.
  3. Remove the bolts and the bracket.
    • To install, tighten to 25 Nm (18 lb-ft).
      Fig 1: Locating Bolts And Bracket
      G04620658Courtesy of FORD MOTOR CO.
  4. Remove the nuts, bolt and the insulator.
    • To install, tighten the nuts to 90 Nm (66 lb-ft).
    • To install, tighten the bolt to 90 Nm (66 lb-ft).
      Fig 2: Locating Nuts, Bolt And Insulator
      G04620659Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals