Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the transaxle is in the NEUTRAL position.

Fig 1: Locating TR Sensor & Bolts

Courtesy of FORD MOTOR CO.

Install the TR sensor and loosely install the bolts.
Using the special tool, align the TR sensor and tighten the bolts.
- Tighten to 11 N.m (8 lb-ft).
  
  Fig 2: Aligning TR Sensor Using Special Tools
  Courtesy of FORD MOTOR CO.
Connect the TR sensor electrical connector.

Fig 3: Locating TR Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Install the battery and tray. For additional information, refer to REMOVAL AND INSTALLATION .
Check the correct operation. The engine should start only in PARK or NEUTRAL. The reverse lamps should illuminate in the REVERSE position.