LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 343 (Automatic Transmission - Cd4E) >> Disassembly And Assembly Of Subassemblies >> Low One-Way Clutch Assembly >> Disassembly

Low One-Way Clutch Assembly: Disassembly

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the low one-way clutch components:
    1. Low one-way clutch inner race
    2. Roller assemble
    3. Low one-way clutch outer race
    4. Outer race groove
    5. Inner race groove
      Fig 1: Inspecting Low One-Way Clutch Components
      G04620271Courtesy of FORD MOTOR CO.
  2. Position the low one-way clutch so the inner and outer race grooves are facing upward.
    Fig 2: Locating Inner & Outer Race Grooves Are Facing Upward
    G04620272Courtesy of FORD MOTOR CO.
  3. Remove the inner race.
    Fig 3: Locating Inner Race
    G04620273Courtesy of FORD MOTOR CO.
  4. Remove the roller assembly.
    Fig 4: Locating Roller Assembly
    G04620274Courtesy of FORD MOTOR CO.
    5. WARNING: Air pressure must not exceed 138 kPa (20 psi). Wear safety glasses when using compressed air. Failure to follow these instructions can result in personal injury.
  5. Clean all parts thoroughly in clean solvent and blow dry with moisture-free regulated compressed air.
  6. Inspect the low one-way clutch parts for damage and wear.
    • Outer race
    • Sprag assembly
    • Inner race
    • Lubrication holes
scientia non olet · About LEMON Manuals