LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 343 (Automatic Transmission - Cd4E) >> Diagnosis And Testing >> Preliminary Inspection >> Fluid Level Check

Fluid Level Check

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Park the vehicle on a level surface and engage the parking brake.
  2. With your foot on the brake, start the engine and move the range selector lever through all the gear ranges. Allow sufficient time for each gear to engage.
  3. Place the range selector in PARK (P) and leave the engine running.
  4. Remove the fluid level indicator and wipe it clean with a clean cloth.
  5. Install the fluid level indicator, making sure that it is fully seated in the filler tube.
  6. Remove the fluid level indicator. The fluid should be in the designated areas for normal and room temperature.
    Fig 1: Identifying Fluid Level Mark On Dip Stick
    G04619757Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals