LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 341 (HVAC Control System) >> Removal And Installation >> High-Pressure Cutoff Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the high-pressure cutoff switch electrical connector.
  2. Remove the high-pressure cutoff switch.
    • Discard the O-ring seal.
  3. To install, reverse the removal procedure.
    • Install a new O-ring seal.
scientia non olet · About LEMON Manuals