LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 335 (Engine Cooling - (Except Hybrid)) >> Removal And Installation >> Radiator - 2.3L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this article.
  3. Remove the cooling fan motor and shroud. For additional information, refer to COOLING FAN MOTOR AND SHROUD  in this article.
  4. Disconnect the upper radiator-to-degas bottle hose from the radiator.
  5. Disconnect the upper radiator hose from the radiator.
  6. Disconnect the lower degas bottle-to-radiator hose from the radiator.
  7. Disconnect the lower radiator hose from the radiator.
  8. Disconnect the 2 transaxle cooling hoses from the radiator.
  9. Remove the radiator.
  10. To install, reverse the removal procedure.
  11. Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  in this article.
scientia non olet · About LEMON Manuals