Tire Pressure Monitoring System (TPMS) Strap and Cradle: Disassembly
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Tire pressure sensors are manufactured in multiple colors based on their application. When installing a new sensor, make sure the color of the sensor being installed matches the color of the sensor that was removed. The different colored sensors are not interchangeable.
NOTE:
The sensor is available separately, the cradle and strap are available as a strap kit. There are several different strap kits available based on wheel diameter but all strap kits share the same base part number.
NOTE:
Tire pressure sensors are equipped with Lithium-ion batteries and must be disposed of accordingly.
- Remove the tire pressure monitoring system (TPMS) sensor. For additional information, refer to TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR in this article.
- Remove a factory installed strap in the following sequence:
- Locate the strap buckle and secure the strap to the wheel using duct tape or a similar item, on both sides of the buckle approximately 25 mm (0.98 in) from the buckle.
- Using a large screwdriver and a twisting motion, unbuckle the strap.
- Discard the strap.
- To remove a dealer installed strap, turn the worm gear screw until the strap is fully released from the worm gear.
- Discard the strap.
- Using a screwdriver, or similar tool, remove the cradle by inserting the screwdriver under the cradle and prying up.
WARNING:
The tire pressure monitoring system (TPMS) band is under tension. Always use safety goggles or a face shield and gloves when removing the TPMS band/strap. Failure to follow these instructions may result in personal injury.
NOTE:
To aid assembly, mark the location of the cradle prior to disassembly.