LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Brake System - General Information) >> Diagnosis And Testing >> Brake System - Hybrid >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART

Condition Possible Sources Action
  • No communication with the anti-lock brake system (ABS) module
  • Circuitry.
  • ABS module.
  • The red brake warning indicator is always on
  • Circuitry.
  • Brake fluid level switch.
  • Parking brake switch.
  • Instrument cluster.
  • Anti-lock brake system (ABS) module.
  • The red brake warning indicator is never on
  • Bulb.
  • Instrument cluster.
  • Brakes drag
  • Parking brake component.
  • Brake caliper guide pins.
  • Disc brake caliper.
  • Brake master cylinder.
  • CARRY OUT the in this section.
  • Excessive brake pedal effort
  • Brakes are in manual mode.
  • Clicking noise - with brakes applied and anti-lock brake system (ABS) engaged
  • ABS hydraulic control unit.
  • Acceptable condition.
  • Squealing noise - occurs on first (morning) brake application
  • Brake pads.
  • Acceptable condition. Caused by humidity and low brake pad temperature.
  • Squealing noise - a continuous squeal
  • Brake pads worn below minimum thickness.
    NOTE: The rear brake pads wear at approximately twice the rate of the front brake pads.
  • INSPECT the brake pads for excessive wear, taper wear or uneven wear. VERIFY the brake pads are within the minimum specifications. REFER to FRONT DISC BRAKE for the front disc brakes or REAR DISC BRAKE for the rear disc brakes.
  • Grinding noise - continuous
  • Brake pads worn below minimum thickness.
    NOTE: The rear brake pads wear at approximately twice the rate of the front brake pads.
  • INSPECT the brake pads for excessive wear taper wear or uneven wear. VERIFY the brake pads are within the minimum specifications. REFER to FRONT DISC BRAKE for front disc brakes or REAR DISC BRAKE for rear disc brakes.
  • Moaning noise
  • Brake linings contaminated with grease or oil.
  • INSPECT the brake pads for contamination. REPAIR or INSTALL new components as necessary. REFER to FRONT DISC BRAKE for front disc brakes or REAR DISC BRAKE for rear disc brakes.
  • Brake vibration/shudder - occurs when the brake pedal is released
  • Brake caliper guide pins.
  • INSPECT the brake caliper guide pins for correct operation. REFER to FRONT DISC BRAKE .
  • Brake drag.
    NOTE: The rear brake pads wear at approximately twice the rate of the front pads.
  • INSPECT the brake pads for premature wear. REPAIR or INSTALL a new caliper as necessary. REFER to FRONT DISC BRAKE for front disc brakes or REAR DISC BRAKE for rear disc brakes.