LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Safety Belt System) >> Removal And Installation >> Safety Belt Retractor - Rear, Center >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters [if so equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.
The automatic locking retractor (ALR) feature of the safety belt retractor must be checked by a qualified technician to verify that the ALR feature for a child safety seat is functioning correctly, in addition to other checks for correct safety belt system function. A new belt and retractor assembly must be installed if the safety belt assembly's "automatic locking retractor" feature or any other safety belt function is not operating correctly when inspected according to the functional inspection procedures. Failure to install a new belt and retractor assembly could increase the risk of injury in collisions.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. For police vehicles equipped with fire suppression, depower the fire suppression system.
  2. Remove the rear seat cushion and rear seat back. For additional information, refer to SEATING .
  3. Disengage the safety belt from the bezel and remove the parcel shelf trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. Remove the nut and rear center safety belt retractor anchor.
    • To install, tighten to 55 Nm (41 lb-ft).
  5. Remove the bolt and safety belt retractor.
    • To install, tighten to 40 Nm (30 lb-ft).
    6. NOTE: Make sure the safety belt retractor anti-rotation tab is engaged to the package tray sheet metal.
    NOTE: Make sure the safety belt webbing is not twisted prior to installation.
  6. To install, reverse the removal procedure
    7. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  7. For police vehicles equipped with fire suppression, repower the fire suppression system.
  8. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals