LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Safety Belt System) >> General Procedures >> Safety Belt Tongue Rotated on Belt

Safety Belt Tongue Rotated on Belt

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Grasp the belt tongue and pull the belt webbing down to form a loop through the slot in the tongue.
    Fig 1: Pulling Belt Webbing Down To Form Loop
    G04586251Courtesy of FORD MOTOR CO.
  2. Rotate and fold the belt webbing over itself within the slot to remove the twist.
  3. Pull the excess belt webbing back through the slot in the belt tongue.
  4. Pull the excess belt webbing through the slot.
  5. The safety belt tongue should face inward when completed.
    Fig 2: Identifying Safety Belt Tongue Facing Inward When Completed
    G04586252Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals