LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 279 (Exterior Lighting System) >> Removal And Installation >> Side Turn Signal Lamp >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the 3 pin-type retainers and the radiator sight shield.
    Fig 1: Locating Three Pin-Type Retainers And Radiator Sight Shield
    G04585563Courtesy of FORD MOTOR CO.

    2. Crown Victoria 

  2. Remove the side turn signal lamp screw.
  3. Remove the nut and the side turn signal assembly.
    • Disconnect the electrical connector.
    • To install, tighten to 5 Nm (44 lb-in).

    4. Grand Marquis 

  4. Remove the 2 nuts and the side turn signal assembly.
    • Disconnect the electrical connector.
    • To install, tighten to 5 Nm (44 lb-in).

    5. All vehicles 

  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals