LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (Front Suspension) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel stud.
    1. Install 4 washers onto the wheel stud.
    2. Install the wheel nut. Tighten the wheel nut until the wheel stud seats fully onto the wheel hub flange.
      Fig 1: Installing Wheel Stud
      G04582718Courtesy of FORD MOTOR CO.
  2. Remove the wheel nut and washers.
  3. Install the brake disc.
  4. Position the caliper and anchor plate assembly onto the steering knuckle, and install the bolts.
    • To install, tighten to 160 Nm (118 lb-ft).
    5. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  5. If equipped with fire suppression system, repower the system.
  6. If equipped, turn the air suspension service switch to the ON position.
scientia non olet · About LEMON Manuals