Fuel Aeration Test
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford RV Cutaway, 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
Install a clear hose on the fuel return line at the fuel control module. Refer to FUEL TANK AND LINES .
Run at the engine at WOT for 2 minutes.
The return fuel should be free of bubbles.
FUEL AERATION CHECKING METHOD
| Method | Check |
|---|---|
| Visual |
- Remove the fuel return line at the fuel control module.
- Attach a 1/4 inch diameter hose (clear) to the fuel control module and place the other end of the hose into Rotunda Tool 034-00005 or equivalent.
- Turn the ignition on. The fuel pump will cycle on, then off. Diesel fuel may not flow out through the attached hose after only one key cycle. Repeat the key cycle until fuel flows from the attached hose.
- Start the engine.
- Run at WOT for 2 minutes. Return fuel should be free of bubbles.
- If the fuel has air in it, the fuel returning to the tank will appear white, foamy or non-transparent. If no or very little air is present in the fuel, the fuel will appear clear/transparent.
- If air is present in the return fuel, inspect the fuel system for leaks.