LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Engine Controls - Diagnostic Subroutines -- 6.0L (99P F450/550) Diesel) >> Hard Start/No Start Diagnostic Procedures >> 11. Glow Plug System Operation >> Recommended Procedure:

Recommended Procedure:

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford RV Cutaway, 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Check for poor connections or loose fitting pins.
NOTE: Incorrect measurements will result if all glow plug connectors are not disconnected.

The glow plug monitor self-test is a KOER functional test of the glow plug system. The self-test is carried out on-demand with the engine running and the A/C off. The PCM will activate the GPCM which monitors the glow plugs. The pedal may be used to increase the engine speed to increase voltage if needed. For fault detection, the self-test requires a fault present at the time of testing.

Fig 1: Glow Plug System Diagram
G04586913Courtesy of FORD MOTOR CO.