LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 205 (Bumper System) >> Removal And Installation >> Front Bumper Cover - Five Hundred, Montego >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 front bumper cover scrivets.
  2. Remove the 2 front bumper cover bolts.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Remove the 3 front bumper cover lower retainers.
  4. Remove the 6 front bumper cover wheel house screws.
    • To install, tighten to 2 Nm (18 lb-in).
  5. If equipped, disconnect the fog lamps electrical connector.
    6. NOTE: The rearward upper portion of the bumper cover must be pulled outward to unclip it from the fender.
    Fig 1: Removing Front Bumper Cover (Five Hundred, Montego)
    G03989370Courtesy of FORD MOTOR CO.
  6. Remove the front bumper cover.
  7. Inspect the bumper cover mounting reinforcements for damage. If necessary, install new bumper cover mounting reinforcements.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals