LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Auxiliary Climate Control) >> Removal And Installation >> Auxiliary Climate Control Housing >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Recover the refrigerant. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
  3. Remove the LH quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. Drain the engine coolant. For additional information, refer to ENGINE COOLING .
  5. Remove the LH rear wheel and tire assembly.
  6. Remove the LH rear wheel opening splash shield.
  7. Release the auxiliary heater inlet hose clamp and disconnect the auxiliary heater inlet hose.
  8. Release the auxiliary heater outlet hose clamp and disconnect the auxiliary heater outlet hose.
  9. Remove the auxiliary evaporator outlet line fitting nut and disconnect the fitting.
    • To install, tighten to 8 Nm (71 lb-in).
  10. Remove the auxiliary evaporator inlet line fitting nut and disconnect the fitting.
    • To install, tighten to 8 Nm (71 lb-in).
  11. Remove the 2 floorpan bracket nuts.
    • To install, tighten to 3 Nm (27 lb-in).
  12. Remove the 2 auxiliary duct pin-type retainers and detach the auxiliary ducts.
  13. Disconnect the 2 auxiliary climate control housing electrical connectors.
  14. Detach the auxiliary blower motor relay pin-type retainer(s).
  15. Remove the 3 auxiliary climate control housing bolts.
    • To install, tighten to 6 Nm (53 lb-in).
  16. Remove the auxiliary climate control housing.
  17. To install, reverse the removal procedure.
  18. Fill the engine coolant. For additional information, refer to ENGINE COOLING .
  19. Evacuate, leak test and charge the refrigerant system. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
scientia non olet · About LEMON Manuals