LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 179 (Steering Column Switches) >> Removal And Installation >> Multifunction Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN .
  2. Remove the instrument cluster finish panel and the steering column upper shroud as an assembly.
    • Remove the 2 instrument cluster finish panel screws.
    • Press the sides of the upper steering column shroud inward to release it from the lower steering column shroud.
  3. Remove the 3 lower steering column shroud screws and the lower shroud.
  4. Disconnect the 3 electrical connectors.
  5. Remove the 4 screws and the multifunction switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals