Inspection and Verification: Notes
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION
Mechanical Electrical - Binding linkage
- Misaligned door
- Battery junction box (BJB) fuse(s):
- 1 (80A)
- 29 (80A)
- Smart junction box (SJB) fuse 3 (25A)
- RKE keypad
- RKE transmitter
- Circuitry
- SJB
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step. If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the key position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual.
- Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
- CAN circuit fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
- No response/not equipped for SJB, go to MULTIFUNCTION ELECTRONIC MODULES .
- System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out self-test diagnostics for the SJB.
- If the DTCs retrieved are related to the concern, go to the SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .