LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Automatic Transmission - CVT) >> In-Vehicle Repair >> Manual Control Lever Shaft Seal >> Removal

Manual Control Lever Shaft Seal: Removal

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: MERCON®, MERCON®V, MERCON®SP, Motorcraft Premium Automatic Transmission Fluid and Motorcraft Continuously Variable Chain Type Transmission Fluid are not interchangeable transmission fluids. The use of any fluid other than what is recommended for this transmission will cause transmission damage.
  1. Remove the battery and battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the shift cable end.
    Fig 1: Disconnecting Shift Cable End
    G03990221Courtesy of FORD MOTOR CO.
  3. Remove the roll pin and the manual lever.
    Fig 2: Removing Roll Pin And Manual Lever
    G03990795Courtesy of FORD MOTOR CO.
  4. Using a suitable pick, remove the selector shaft seal.
    Fig 3: Removing Selector Shaft Seal
    G03990796Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals