DTC P2510: ECM/Pcm Power Relay Sense Circuit Range/Performance

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

P2510 - ECM/PCM POWER RELAY SENSE CIRCUIT RANGE/PERFORMANCE

Description:	The powertrain control module (PCM) monitors the voltage on the ignition switch position run (ISP-R) and the fuel injector power monitor (INJPWRM) circuits. This DTC sets when the voltage on the ISP-R and the INJPWRM circuit voltages do not correspond for a calibrated period of time.
Possible Causes:	Ignition circuit fuse ISP-R circuit open in the harness ISP-R circuit short to ground in the harness Fuel injector VPWR circuit short to voltage Fuel injector INJPWR circuit short to voltage Damaged ignition switch Damaged fuel pump relay Damaged PCM power relay
Diagnostic Aids:	The INJPWRM PID voltage reading should be 0 volts when the ignition is in the OFF, ACC or LOCK position.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST B .