LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1609 (Engine Controls - Pinpoint Test JD: Crankshaft Position (CKP) Sensor Through Pinpoint Test KJ: Supercharger Bypass Control - (Except Diesel & Hybrid)) >> Pinpoint Test KA: Fuel Pump (FP) Relay >> Introduction

Pinpoint Test KA: Fuel Pump (FP) Relay: Introduction

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, 2010 Lincoln Town Car, and 2010 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the following:

The VPWR and FP circuits may be reversed in the harness connector. Refer to the appropriate SYSTEM WIRING DIAGRAMS article for schematic and connector information.

Fig 1: Fuel Pump (FP) Relay Connector
G06290672Courtesy of FORD MOTOR CO.
Fig 2: Inertia Fuel Shutoff (IFS) Switch Connector
G06290673Courtesy of FORD MOTOR CO.

For PCM connector views or reference values, refer to REFERENCE VALUES .

POWERTRAIN CONTROL MODULE (PCM) CONNECTOR PIN REFERENCE CHART

Vehicle Connector Pin Circuit
Focus,
Transit Connect
190-Pin B32
B19
FPM
FP
Fusion,
MKZ
140 Pin B30
B62
FPM
FP
Ranger 170 Pin B21
B12
FPM
FP
All other vehicles 190-Pin B30
B62
FPM
FP