Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Fusion, Milan

Remove the access cover and the screw.
Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the front locking tab.

Fig 1: Disengaging Front Locking Tab
Courtesy of FORD MOTOR CO.

MKZ

NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.

Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly rearward to disengage the front locking tab.
All Vehicles
Disconnect the electrical connector(s).
Remove the window control switch.
To install, reverse the removal procedure.