LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Transfer Case - Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Output Flange >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .
  2. Remove the output flange nut.
    • To install, tighten to 100 Nm (74 lb-ft).
      Fig 1: Removing Output Flange Nut
      G03992047Courtesy of FORD MOTOR CO.
  3. Remove the output flange.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals