LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Clutch Controls) >> Removal And Installation >> Clutch Pedal >> Removal

Clutch Pedal: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery and the battery tray. For additional information, refer to BATTERY, MOUNTING & CABLES -- FUSION, MILAN & MKZ article.
  2. Remove the PCM.
    1. Disconnect the electrical connectors.
    2. Remove the 2 PCM bolts.
    Fig 1: Identifying PCM Electrical Connectors And Mounting Bolts
    G06275845Courtesy of FORD MOTOR CO.
  3. Remove the 3 PCM bracket nuts and the bracket.
    Fig 2: Locating PCM Bracket Nuts
    G07786510Courtesy of FORD MOTOR CO.
  4. Remove the clutch master cylinder nut.
    Fig 3: Locating Clutch Master Cylinder Nut
    G07786511Courtesy of FORD MOTOR CO.
  5. Working under the instrument panel, disconnect the clutch switch (cruise control cancel) electrical connector.
  6. Disconnect the Clutch Pedal Position (CPP) electrical connector.
  7. Remove the clutch master cylinder nut and the clutch pedal bracket nut.
    Fig 4: Locating Clutch Master Cylinder Nut And Clutch Pedal Bracket Nut
    G06275849Courtesy of FORD MOTOR CO.
  8. Remove the clutch pedal and bracket assembly.
scientia non olet · About LEMON Manuals