LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1578 (Anti-Theft System - Passive Anti-Theft System (Pats) (Except Hybrid)) >> Diagnosis And Testing >> MyKey® Restrictions on Vehicle Operation >> Symptom Chart

Symptom Chart

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM CHART

Condition Possible Sources Action
  • No known admin key available
  • The admin key is lost/stolen
  • Aftermarket remote start system has been programmed as the admin MyKey®
  • REFER to MYKEY® PROGRAMMING  in this service information to clear all programmed MyKeys®. PROGRAM the aftermarket remote start system as a MyKey®.
  • No MyKey® messages available
  • Unlimited key mode is enabled
  • INFORM the customer of the normal vehicle operation. If the customer desires MyKey® to be enabled, DISABLE the unlimited key mode. REFER to SPARE KEY PROGRAMMING - UNLIMITED KEY MODE  in this service information.
  • MyKey® acts as an admin key
  • Aftermarket remote start system was used to start the vehicle
  • REFER to MYKEY® PROGRAMMING  in this service information to clear all programmed MyKeys®. PROGRAM the aftermarket remote start system as a MyKey®.
  • Cannot locate the MyKey® restricted key
  • The MyKey® restricted key is lost/stolen
  • All keys have been programmed to a MyKey® restricted key status
  • Aftermarket remote start system has been programmed as the admin MyKey®
  • REFER to MYKEY® PROGRAMMING  in this service information to clear all programmed MyKeys®. PROGRAM the aftermarket remote start system as a MyKey®.
  • Total number of admin keys and MyKeys® programmed includes one more key than customer has
  • An unauthorized key has been programmed to the vehicle as a MyKey® restricted key or as an admin key
  • The vehicle has an aftermarket remote start system
  • INFORM the customer of the normal vehicle operation. RELEASE the vehicle to the customer. If necessary, REFER to CLEAR MYKEY® RESTRICTED FEATURES  in this service information to clear all programmed MyKeys®. This action also clears any MyKey® restrictions the remote start system may have.
  • The MyKey® distance does not accumulate
  • The MyKey® is not being used by the intended driver
  • The MyKey® system has recently been cleared
  • MAKE SURE the key being used is a MyKey® restricted key by observing the message center messages when the vehicle is started using the MyKey®. VERIFY the MyKey® restricted key is being used by driving the vehicle using the MyKey® restricted key and checking the miles accumulated before and after the drive.
  • Cannot create a MyKey®
  • Engine was started using an aftermarket remote start system that is programmed as a MyKey® restricted key
  • MyKey® restricted key is already in the ignition lock cylinder
  • Unlimited key mode is enabled
  • INFORM the customer of the normal vehicle operation. If the customer desires MyKey® to be enabled, DISABLE the unlimited key mode. REFER to SPARE KEY PROGRAMMING - UNLIMITED KEY MODE  in this service information.
  • Key in the ignition lock cylinder is the only one admin key left
  • INFORM the customer of the normal vehicle operation. There must always be one admin key.
  • Cannot configure/clear the MyKey® feature
  • MyKey® restricted key in the ignition lock cylinder
  • Engine was started using an aftermarket remote start system that is programmed as a MyKey® restricted key
  • INFORM the customer of the normal vehicle operation. An admin key must be used to configure or clear MyKey®
  • No MyKey® restricted keys are programmed
  • PROGRAM MyKey®. REFER to MYKEY® PROGRAMMING  in this service information, for the programming procedures.