Selector Lever Bezel: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Be sure that the override lever is inserted in the override lever guide or the shift interlock override button will not work correctly.

NOTE: Selector lever removed for clarity.

Fig 1: Locating Locking Tabs

Courtesy of FORD MOTOR CO.

Install the selector lever bezel on the selector lever.
- Position the override lever in the override lever guide.
- Make sure that the 3 locking tabs are locked in place.
Connect selector lever bezel electrical connector.

Fig 2: Locating Selector Lever Bezel Electrical Connector
Courtesy of FORD MOTOR CO.
Install the selector lever knob on the selector lever and install the screws.

Fig 3: Locating Selector Lever Knob Screws
Courtesy of FORD MOTOR CO.
Slide the selector lever knob bezel up and install it on the selector lever knob.

Fig 4: Sliding Selector Lever Knob Bezel Up
Courtesy of FORD MOTOR CO.
Position the utility tray in place and connect the electrical connector.

Fig 5: Locating Utility Tray Electrical Connector
Courtesy of FORD MOTOR CO.
Install the utility tray on the center console.

Fig 6: Locating Utility Tray Of Center Console
Courtesy of FORD MOTOR CO.
Install the center console trim panel.

Fig 7: Locating Center Console Trim Panel
Courtesy of FORD MOTOR CO.
Install the selector lever trim ring.

Fig 8: Locating Selector Lever Trim Ring

Courtesy of FORD MOTOR CO.