LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1527 (Steering Column Switches) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The steering column opening cover is held in place by tabs that clip to the instrument panel.
  1. Remove the steering column opening cover by pulling straight outward.
    2. NOTE: Release the upper steering column shroud, by pressing inward on the sides of the shroud and lifting upwards.
  2. Remove the upper steering column shroud.
  3. Release the tilt lever, remove the 3 lower steering column shroud screws and then the shroud.
  4. Disconnect the multifunction switch electrical connector.
  5. Remove the 2 multifunction switch screws and the switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals