Normal Operation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
The ignition switch is spring loaded to automatically return to the RUN position after being placed in the START position. A microprocessor in the Smart Junction Box (SJB) monitors the voltage output from the ignition switch while the switch is in the START position. This microprocessor is also connected to the Audio Control Module (ACM) start circuit, so a short to voltage on the ignition switch output circuit or on the ACM start circuit could cause DTC B2A20 to set.
- B2A20 (Ignition Stuck in START) - The SJB continuously monitors the ignition switch state, if the SJB receives a START signal for more than 30 seconds, DTC B2A20 will be set.
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Ignition switch
- SJB
- PCM
- ACM