DTC P0010: Intake Camshaft Position Actuator Circuit/Open (Bank 1)
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0010 - INTAKE CAMSHAFT POSITION ACTUATOR CIRCUIT/OPEN (BANK 1)
| Description: | The comprehensive component monitor (CCM) monitors the variable cam timing (VCT) circuit to the powertrain control module (PCM) for high and low voltage. If during testing the voltage falls below a calibrated limit for a calibrated amount of time the test fails. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | This DTC is a circuit check. Testing should include the harness and solenoid coil. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to HK: Variable Cam Timing (VCT) STEP HK1. | ||