Removal and Installation
WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
ITEM DESCRIPTION
| Item | Part Number | Description |
|---|---|---|
| 1 | W503278 | Oil pump screen and pickup tube bolt (2 required) - 10 Nm (89 lb-in) |
| 2 | 6625 | O-ring seal |
| 3 | 6622 | Oil pump screen and pickup tube |
NOTE:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan may cause engine failure.
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the oil pan. For additional information, refer to OIL PAN in this service information.
- Remove the 2 bolts and the oil pump screen and pickup tube.
- Discard the O-ring seal.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Install a new O-ring seal.