LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Windows And Glass) >> Removal And Installation >> Door Glass Run and Bracket - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the rear door module. For additional information, refer to WINDOW REGULATOR MOTOR - REAR DOOR .
  3. Lower the rear door window glass into the door.
  4. Remove the scrivet.
    Fig 1: Removing Scrivet
    G03989107Courtesy of FORD MOTOR CO.
  5. Remove the rear door glass top run bolt.
    Fig 2: Removing Rear Door Glass Top Run Bolt
    G03989108Courtesy of FORD MOTOR CO.
  6. Remove the rear door glass inner weatherstrip.
  7. Carefully position the glass aside, then remove the rear door glass top run.
  8. To install, reverse the removal procedure.