DTC P115E: Throttle Actuator Control (TAC) Throttle Body Air Flow Trim At Max Limit
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, 2011 Ford Fusion, 2010 Mercury Milan, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
P115E - THROTTLE ACTUATOR CONTROL (TAC) THROTTLE BODY AIR FLOW TRIM AT MAX LIMIT
| Description: | During idle, the powertrain control module (PCM) monitors the throttle angle and air flow. If the air flow is determined to be less than expected, the PCM adjusts the throttle angle to compensate. The air flow reduction is typically the result of engine deposit buildup around the throttle plate. This DTC indicates the PCM has reached the maximum allowed compensation and is no longer able to compensate for the buildup. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Install a new throttle body. Refer to the appropriate Fuel Charging and Controls article. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC in table | ||