Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A new wiper motor assembly comes with the linkage arm installed.

Remove the wiper mounting arm and pivot shaft. For additional information, refer to Wiper Mounting Arm and Pivot Shaft .

NOTE: Do not remove the wiper motor linkage arm from the wiper motor assembly. If the arm is removed, the wiper arms may not park in the correct location.

Separate the wiper motor linkage arm from the wiper mounting arm and pivot shaft assembly.
- Use a suitable tool at the location shown in illustration to separate the wiper linkage arm from the wiper mounting arm and pivot shaft assembly.

Fig 1: Identifying Wiper Mounting Arm

Courtesy of FORD MOTOR CO.

Remove the 3 windshield wiper motor bolts.
- To install, tighten to 15 N.m (11 lb-ft).

Fig 2: Identifying Windshield Wiper Motor Bolts

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.