LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1454 (Anti-Theft System - Perimeter) >> Removal & Installation >> Door Disarm Switch >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH front door trim panel. For additional information, refer to REMOVAL AND INSTALLATION article.
  2. Position the watershield aside.
  3. Disconnect the door lock cylinder actuating rod from the door lock cylinder actuating pawl.
  4. Remove the E-clip.
  5. Remove the door lock cylinder actuating pawl.
  6. Disconnect the electrical connector and remove the door disarm switch.
  7. To install, reverse the removal procedure.
    • The door disarm switch mark must be positioned towards the harness side of the switch prior to installation.
    8. Fig 1: Identifying Door Disarm Switch Mark
    GF0001423Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals