Selector Lever Indicator Adjustment
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the lower steering column opening finish panel.
- Remove the screw and position the parking brake release handle aside.
- Remove the screw from the lower steering column opening finish panel.
- Pull outward to release the retaining clips and remove the lower steering column opening finish panel.
- Remove the 5 screws and the lower steering column opening finish panel reinforcement.
- Rotate the selector lever clockwise until it bottoms out in 1st gear, then rotate it counterclockwise 2 detents to the Overdrive (Circle D) position.
- Hang a 1.4 kg (3 lb) weight on the selector lever.
- Rotate the thumbwheel to center the selector lever indicator in the middle of the Overdrive (Circle D) position.
- Remove the weight.
- Rotate the selector lever into each detent to verify that the selector lever indicator matches the selected range. Readjust, if necessary.
- Install the lower steering column opening finish panel reinforcement.
- Install the lower steering column opening finish panel and parking brake release handle.