Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Installation of a new receiver/drier is not required when repairing the air conditioning system except when there is physical evidence of system contamination from a failed A/C compressor or damage to the receiver/drier.
- Recover the refrigerant. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
- Remove the 4 roll restrictor cross beam bolts.
- To install, tighten to 55 Nm (41 lb-ft).
- Remove the roll restrictor bracket bolt.
- To install, tighten to 48 Nm (35 lb-ft).
- Remove the TXV manifold bolt.
- Discard the O-ring seals.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the 2 TXV bolts.
- To install, tighten to 8 Nm (71 lb-in).
- Remove the TXV.
- Discard the O-ring seals.
- To install, reverse the removal procedure.
- Install new O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
- Evacuate, leak test and charge the refrigerant system. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .