LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine) >> In-Vehicle Repair >> Oil Pressure Sender >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove cooling fan motor and shroud. For additional information, refer to ENGINE COOLING .
  3. Remove the lower radiator splash shield.
  4. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  5. Disconnect the A/C compressor electrical connector and wiring harness retainer.
  6. Remove the 2 bolts, 2 nuts and position the A/C compressor aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  7. Remove the 6 bolts and position the A/C compressor bracket aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  8. Disconnect the oil pressure sender electrical connector.
  9. Remove the oil pressure sender.
    • To install, tighten to 14 Nm (10 lb-ft).
  10. To install, reverse the removal procedure.
    • Apply pipe sealant with Teflon® to the oil pressure sender threads.
scientia non olet · About LEMON Manuals