LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1434 (Engine Mechanical - 4.6L (2V)) >> In-Vehicle Servicing >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The valve stem seal must be bottomed on the valve seat.
    NOTE: Make sure that the garter spring is present in the valve stem seal.
  1. Use the Valve Spring Compressor and Valve Stem Oil Seal Installer to install the valve stem seals.
    2. Fig 1: Installing Valve Stem Seals
    GF0013582Courtesy of FORD MOTOR CO.
  2. Install the valve springs. For additional information, refer to Valve Springs .
scientia non olet · About LEMON Manuals