Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the generator. For additional information, refer to CHARGING SYSTEM - GENERAL INFORMATION article.
Install the Engine Lifting Bracket.

Fig 1: Special Tool

Courtesy of FORD MOTOR CO.

Install the Engine Support Bar.

Fig 2: Special Tool

Courtesy of FORD MOTOR CO.

Remove the RH and LH lower engine mount nuts.
- To install, tighten to 90 Nm (66 lb-ft).
Using the Engine Support Bar, raise the engine.

Fig 3: Special Tool

Courtesy of FORD MOTOR CO.

Remove the 3 bolts and the RH engine mount.
- To install, tighten to 70 Nm (52 lb-ft).
To install, reverse the removal procedure.