LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1433 (Automatic Transmission - Automatic Transaxle/Transmission - 4R70E/4R75E) >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Disconnect the output shaft speed (OSS) sensor electrical connector.
  3. Remove the OSS sensor bolt and the sensor.
    • To install, tighten to 12 Nm (9 lb-ft).
    4. Fig 1: Output Shaft Speed Sensor & Bolt
    GF0014086Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals