LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1433 (Automatic Transmission - Automatic Transaxle/Transmission - 4R70E/4R75E) >> Diagnostic Tests >> Pinpoint Tests - OSC Equipped Vehicle >> Pinpoint Tests >> Pinpoint Test G: Solenoid Mechanical Failure

Pinpoint Test G: Solenoid Mechanical Failure

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Repair all other DTCs before repairing the following DTCs: P1714, P1715, P1740.
  1. G1 ELECTRONIC DIAGNOSIS 
    • Connect the diagnostic tool.
    • Carry out Key ON Engine OFF (KOEO) Test.
    • Are only DTCs P1714, P1715 and P1740 present? 
    1. YES  : INSTALL a new solenoid and/or body. REFER to the DTC Charts  for code description. Go to  G2 .
    2. NO  : REPAIR the other DTCs first. CLEAR DTCs and CARRY OUT Transmission Drive Cycle Test. TEST the system for normal operation.
  2. G2 TRANSMISSION DRIVE CYCLE TEST 
    • Carry out Transmission Drive Cycle Test.
    • Retrieve DTCs.
    • Does the vehicle upshift and downshift OK? 
    1. YES  : Go to  G3.
    2. NO  : REFER to Diagnosis By Symptom  to diagnose shift concerns.
  3. G3 RETRIEVE DTCS 
    • Connect the diagnostic tool.
    • Carry out KOEO Test until continuous DTCs have been displayed.
    • Are DTCs P1714, P1715 and P1740 still present? 
    1. YES  : INSTALL a new PCM. REFER to ELECTRONIC ENGINE CONTROLS article. ROAD TEST and REPEAT Quick Test.
    2. NO  : Testing completed. If a concern still exists, REFER to Diagnosis By Symptom .
scientia non olet · About LEMON Manuals