Lumbar Motor: Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Install the lumbar assembly.
- Attach the lumbar assembly to the top of the backrest frame.
- Attach the bottom of the lumbar assembly to the lower backrest frame retainer.
- Route the cable and motor into position.
- Install the lumbar motor and 2 new rivets.
- Connect the lumbar motor electrical connector.
- Attach the seat backrest trim cover J-clips.
- Attach the 2 side J-clips first and then attach the lower J-clip.
- Install the seat. For additional information, refer to Seat - Front .
NOTE:
Note the alignment of the 2 side J-clips at the top of the seat to avoid bunching of the trim cover material.