Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

Remove the seat. For additional information, refer to Seat - Front .
Release the seat cushion cover J-clips to access the lumbar switch.
Disconnect the electrical connector.
Remove the power lumbar switch.
- Insert a suitable tool between the bezel and power lumbar switch.
- Pry the tab and push the switch through the bezel.

Fig 1: Locating Screwdriver Between Bezel And Power Lumbar Switch

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.