Seat Cushion - Front: Assembly

Passenger seat 

1. Install the OCS system components. For additional information, refer to Occupant Classification Sensor procedure in REMOVAL AND INSTALLATION article.

All seats 

2. Install the cushion support.
3. Position the mat over the cushion support and install the 2 pin-type retainers.
4. Install the cushion trim cover to the foam pad.
   • Install new hog rings at locations noted during disassembly.
Fig 1: Locating Hog Rings
Courtesy of FORD MOTOR CO.
5. Position the cushion foam pad and trim cover to the seat cushion frame.
6. If equipped, install the power lumbar switch and connect the electrical connector.
7. Attach the wiring harness and route as noted during disassembly.
8. Fasten the J-clips.
Fig 2: Locating Seat Backrest Front Section
Courtesy of FORD MOTOR CO.
9. If equipped, connect the heated seat electrical connector.
10. Install the seat track. For additional information, refer to Seat Track .
11. Install the seat backrest. For additional information, refer to Seat Backrest - Front .
12. Install the seat. For additional information, refer to Seat - Front .