Rear Disc Brake: Removal
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the brake pads. For additional information, refer to Brake Pads .
- Insert the tool at the end of the access plug slot farthest from the brake caliper. Engage the adjuster and rotate by raising the end of the tool toward the backing plate. Remove the brake disc.
- Clean any rust or foreign material from the brake disc, the wheel and the wheel hub.
- Use specified brake parts cleaner to clean the brake disc and hub surfaces.
- Apply specified anti-seize lubricant to the hub flange and pilot area.
- To install, reverse the removal procedure.
NOTE:
If the brake disc binds on the rear parking brake shoes and linings, remove the adjustment hole access plug and retract the parking brake shoe and lining, using an adjusting tool.