LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1421 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Caliper >> Installation

Rear Brake Caliper: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the anti-rattle clips are correctly positioned. Install new clips if worn or damaged.
  1. Position the anti-rattle clip on the anchor plate rail.
    2. NOTE: To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.
    NOTE: When installed, the locator notch on the brake pads will be located at the upper end of the rear disc brake caliper.
  2. Position the brake caliper and install the 2 brake caliper bolts.
    • Tighten to 25 Nm (18 lb-ft).
  3. Position the brake hose and install the brake caliper flow bolt using 2 new copper washers.
    • Tighten to 48 Nm (35 lb-ft).
  4. Bleed the brake caliper. For additional information, refer to GENERAL PROCEDURES article for Component Bleeding.
  5. Install the wheel and tire. For additional information, refer to REMOVAL & INSTALLATION article.
scientia non olet · About LEMON Manuals