LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Focus ZX5 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1407 (Charging System - General Information) >> Diagnostic Tests >> Charging System >> Component Tests >> Generator On-Vehicle Tests - Load Test

Generator On-Vehicle Tests - Load Test

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch the tester to the ammeter function.
  2. Connect the positive and negative leads of the tester to the corresponding battery terminals.
  3. Connect the current probe to the generator B+ output terminal, circuit 38 (RD).
  4. With the engine running at approximately 2,000 RPM, adjust the tester load bank to determine the output of the generator. The generator output should be greater than the graph shown in illustration below. If not, refer back to the pinpoint test or Go to Symptom Chart .
    5. Fig 1: Generator On-Vehicle Tests - Load Test Graph
    GF0014503Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals