License Plate Housing
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
ITEM DESCRIPTION
| Item | Part Number | Description |
|---|---|---|
| 1 | 25A22 | License plate housing |
| 2 | W520201 | License plate housing nuts (4 required) |
| 3 | 40010 | Liftgate |
| 4 | - | License plate housing pin-type retainers (part of 5A22) (4 required) |
- Remove the liftgate trim panel. For additional information, refer to LIFTGATE TRIM PANEL .
- Disconnect the license plate housing electrical connector.
- Remove the license plate housing nuts.
- Release the license plate housing pin-type retainers from the liftgate and remove the license plate housing.
- To install, reverse the removal procedure.